Content Curator | Updated On - May 28, 2024
BCECE 2017 Question paper (Set A) is available for download here. BCECE exam was successfully organized by Bihar Combined Entrance Competitive Examination Board on June 18, 2017. The question paper comprised a total of 150 questions divided into 3 sections.
BCECE 2017 Question Paper with Answer Key PDF (Set A)
| BCECE 2017 Question Paper PDF | BCECE 2017 Answer Key PDF |
|---|---|
| Download PDF | Download PDF |
BCECE Previous Year Question Paper with Answer Key PDFs
Similar Exam Question Papers:
BCECE Questions
1. The pattern is observed in which experiment?
The pattern is observed in which experiment?
Increase by about 9%
Decrease by about 10%
Increase by 11%
Decrease by 19%
2. The velocity of light in a medium is √3\(\times\)108m/s. The polarizing angle of incidence is:
The velocity of light in a medium is √3\(\times\)108m/s. The polarizing angle of incidence is:
30°
60°
45°
tan-1 (3)
3. What is the r.m.s value of an alternating current which when passed through a resistor produces heat, which is four times that produced by a current of 2A in the same resistor?
What is the r.m.s value of an alternating current which when passed through a resistor produces heat, which is four times that produced by a current of 2A in the same resistor?
- 2A
- A
- 4A
- 8A
4. If the length of a filament of a heater is reduced by 10% , the power of the heater will:
If the length of a filament of a heater is reduced by 10% , the power of the heater will:
Increase by about 9%
Decrease by about 10%
Increase by 11%
Decrease by 19%
5. A ray of light is incident normally on one face of an equilateral prism (μ=\(\frac{3}{2}\)). The angle of deviation is:
A ray of light is incident normally on one face of an equilateral prism (μ=\(\frac{3}{2}\)). The angle of deviation is:
30°
60°
45°
75°
6. Instantaneous displacement current of 1.0A in the space between the parallel plates of 1μF capacitor can be established by changing the potential difference of:
Instantaneous displacement current of 1.0A in the space between the parallel plates of 1μF capacitor can be established by changing the potential difference of:
10-6 V/S
10-8 V/S
10-6 V/S
10-8 V/S
Comments