
20 cm from the plane mirror, it would be a virtual image.
20 cm from the lens, it would be a real image
30 cm from the lens, it would be a real image.
30 cm from the plane mirror, it would be a virtual image.
To solve this problem, we need to find the location of the final image formed due to the combination of a convex lens and a plane mirror.
The correct answer is: 20 cm from the plane mirror, it would be a virtual image.
A constant voltage of 50 V is maintained between the points A and B of the circuit shown in the figure. The current through the branch CD of the circuit is :
AB is a part of an electrical circuit (see figure). The potential difference \(V_A - V_B\), at the instant when current \(i = 2\) A and is increasing at a rate of 1 amp/second is:
A full wave rectifier circuit with diodes (\(D_1\)) and (\(D_2\)) is shown in the figure. If input supply voltage \(V_{in} = 220 \sin(100 \pi t)\) volt, then at \(t = 15\) msec: 
Light travels a distance x in time t1 in air and 10x in time t2 in another denser medium. What is the critical angle for this medium?
A constant voltage of 50 V is maintained between the points A and B of the circuit shown in the figure. The current through the branch CD of the circuit is :
Which of the following statements are true?
A. Unlike Ga that has a very high melting point, Cs has a very low melting point.
B. On Pauling scale, the electronegativity values of N and C are not the same.
C. $Ar, K^{+}, Cl^{–}, Ca^{2+} and S^{2–}$ are all isoelectronic species.
D. The correct order of the first ionization enthalpies of Na, Mg, Al, and Si is Si $>$ Al $>$ Mg $>$ Na.
E. The atomic radius of Cs is greater than that of Li and Rb.
Choose the correct answer from the options given below:
AB is a part of an electrical circuit (see figure). The potential difference \(V_A - V_B\), at the instant when current \(i = 2\) A and is increasing at a rate of 1 amp/second is:
Lenses that are made by combining two spherical transparent surfaces are called spherical lenses. In general, there are two kinds of spherical lenses. Lenses that are made by joining two spherical surfaces that bulge outward are convex lenses, whereas lenses that are made by joining two spherical surfaces that curve inward are concave lenses.