List of top Physics Questions asked in NEET (UG)

A metallic bar of Young’s modulus, 0.5 × 10¹¹ N m^–2 and coefficient of linear thermal expansion 10^–5 °C^–1, length 1 m and area of cross-section 10^–3 m² is heated from 0°C to 100°C without expansion or bending. The compressive force developed in it is :

A light ray enters through a right angled prism at point P with the angle of incidence 30° as shown in figure. It travels through the prism parallel to its base BC and emerges along the face AC. The refractive index of the prism is :

\(^{290}_{82}X\stackrel{\alpha}{\rightarrow}Y\stackrel{e^+}{\rightarrow}Z\stackrel{\beta^-}{\rightarrow}P\stackrel{e^-}{\rightarrow}Q\)
In the nuclear emission stated above, the mass number and atomic number of the product Q respectively, are :

The quantities which have the same dimensions as those of solid angle are :

A force defined by F = αt² + βt acts on a particle at a given time t. The factor which is dimensionless, if α and β are constants, is :

Two heaters A and B have power rating of 1 kW and 2 kW, respectively. Those two are first connected in series and then in parallel to a fixed power source. The ratio of power outputs for these two cases is :

Match List I with List II.

List I (Spectral Lines of Hydrogen for transitions from)		List II (Wavelength (nm))
A.	n2 = 3 to n1 = 2	I.	410.2
B.	n2 = 4 to n1 = 2	II.	434.1
C.	n2 = 5 to n1 = 2	III.	656.3
D.	n2 = 6 to n1 = 2	IV.	486.1

Choose the correct answer from the options given below:

A thin flat circular disc of radius 4.5 cm is placed gently over the surface of water. If surface tension of water is 0.07 Nm^-1, then the excess force required to take it away from the surface is :

Choose the correct circuit which can achieve the bridge balance.

A 10 µF capacitor is connected to a 210 V, 50 Hz source as shown in figure. The peak current in the circuit is nearly (π = 3.14) :
:

A thermodynamic system is taken through the cycle abcda. The work done by the gas along the path bc is :

The maximum elongation of a steel wire of 1 m length if the elastic limit of steel and its Young’s modulus, respectively, are 8 × 10⁸ N m^–2 and 2 × 10¹¹ N m^–2, is :

Two bodies A and B of same mass undergo completely inelastic one dimensional collision. The body A moves with velocity v₁ while body B is at rest before collision. The velocity of the system after collision is v₂. The ratio v₁ : v₂ is :

A particle moving with uniform speed in a circular path maintains :

An iron bar of length L has magnetic moment M. It is bent at the middle of its length such that the two arms make an angle 60° with each other. The magnetic moment of this new magnet is :

The velocity (v) - time (t) plot of the motion of a body is shown below :

The acceleration (a) - time(t) graph that best suits this motion is :

In an ideal transformer, the turns ratio is \(N_p/N_s\) =1/2 .The ratio \(V_S:V_P\)  is equal to (the symbols carry their usual meaning):

A wheel of a bullock cart is rolling on a level road as shown in the figure below. If its linear speed is v in the direction shown, which one of the following options is correct (P and Q are any highest and lowest points on the wheel, respectively) ?

At any instant of time t, the displacement of any particle is given by 2t – 1 (SI unit) under the influence of force of 5N. The value of instantaneous power is (in SI unit):

If the monochromatic source in Young's double slit experiment is replaced by white light, then coloured fringes. (3) there will be a central bright white fringe surrounded by a few coloured fringes. (4) all bright fringes will be of equal width.

In the above diagram, a strong bar magnet is moving towards solenoid-2 from solenoid-1. The direction of induced current in solenoid-1 and that in solenoid-2, respectively, are through the directions :

A sheet is placed on a horizontal surface in front of a strong magnetic pole. A force is needed to :
A. hold the sheet there if it is magnetic.
B. hold the sheet there if it is non-magnetic.
C. move the sheet away from the pole with uniform velocity if it is conducting.
D. move the sheet away from the pole with uniform velocity if it is both, non-conducting and non-polar.
Choose the correct statement(s) from the options given below :

A horizontal force 10 N is applied to a block 4 as shown in figure. The mass of blocks A and B are 2 kg and 3 kg, respectively. The blocks slide over a frictionless surface. The force exerted by block A on block B is:

The output (Y) of the given logic gate is similar to the output of an/a :

If the mass of the bob in a simple pendulum is increased to thrice its original mass and its length is made half its original length, then the new time period of oscillation is \(\frac{x}{2}\) times its original time period. Then the value of x is :