List of top Nanoelectronics Questions on Electronic devices asked in CUET (PG)

Determine the Y11 and Y12 parameters for the circuit given below:

The consequences of Early effect on BJT are:
(A) Effective base width reduces.
(B) Emitter injection efficiency and base transport factor increase.
(C) $\alpha$ and $\beta$ decrease.
(D) Emitter injection efficiency and base transport factor decrease.
Choose the correct answer:

(A) Tunnel diode is a heavily doped pn junction diode that exhibits negative differential resistance.
(B) Stability factor (S) is the maximum for a voltage divider bias circuit.
(C) The operational amplifier works as a comparator circuit in open loop configuration.
(D) Biasing is done to set the quiescent point of the transistor in the middle of the DC load line.
Choose the correct statements from the options given below:

Arrange the following devices in increasing order of their input resistances:
(A) MOSFET
(B) BJT
(C) JFET
(D) PN junction diode

Following statements are given in reference to 8085 Microprocessor:
(A) Its memory size is 64 KB
(B) It is a 40-pin IC
(C) Its clock frequency lies between 3 to 5 MHz
(D) It has 16 bit of each data and address lines.
Choose the correct answer from the options given below:

(A) MOV A, C is a one-byte instruction.
(B) OUT 03 H is a two-byte instruction.
(C) ANI 76 H is a three-byte instruction.
(D) STA 3000 H is a three-byte instruction.

............ refers to the inability to faithfully repeat recorded data output when measuring a range of values and scanning from different directions.

........ is the vector address of the TRAP interrupt.

What is the word length of an 8-bit microprocessor?