The ore that is concentrated by Froth Floatation process is
Show Hint
Ores concentrated by the froth floatation process include zinc blende (ZnS), Galena (PbS), and cinnabar (HgS).
- Bauxite
- Malachite
- Zincite
- Cinnabar
The Correct Option is D
Approach Solution - 1
The process of Froth floatation is used to concentrate only sulphide ores.
Cinnabar, HgS is a sulphide ore. Therefore, the froth floatation method is used for its concentration.
Approach Solution -2
Ores concentrated by the froth floatation process include zinc blende (ZnS), Galena (PbS), and cinnabar (HgS).
Hence, option D is correct.
Approach Solution -3
Here,
Ores that are concentrated by the fourth floatation process include Galena (PbS), zinc blende (ZnS), and cinnabar (HgS). The process of Froth floatation is used to concentrate only sulfide ores.
Hence, The correct option will be D.
Top Questions on Concentration of ores
- Given below are two statements:
Statement I : In froth floatation method a rotating paddle agitates the mixture to drive air out of it.
Statement II : Iron pyrites are generally avoided for extraction of iron due to environmental reasons.
In the light of the above statements, choose the correct answer from the options given below:- JEE Main - 2023
- Chemistry
- Concentration of ores
- Ferric oxide in blast furnace's upper half is mainly reduced by:
- CUET (UG) - 2023
- Chemistry
- Concentration of ores
- Extraction of which one of the following metals involves concentration of the ore by leaching?
- JEE Main - 2023
- Chemistry
- Concentration of ores
- The methods NOT involved in concentration of ore are
A Liquation
B Leaching
C Electrolysis
D Hydraulic washing
E Froth floatation
Choose the correct answer from the options given below :- JEE Main - 2023
- Chemistry
- Concentration of ores
- Match List-I with List-II.
List-I
List-II
(A) Aluminium (I) Calamine (B) Iron (II) Bauxite (C) Copper (III) Malachite (D) Zinc (IV) Siderite
Choose the correct answer from the options given below:- CUET (UG) - 2023
- Chemistry
- Concentration of ores
Questions Asked in KCET exam
- If \(\lim\limits_{x \rightarrow 0} \frac{\sin(2+x)-\sin(2-x)}{x}\)= A cos B, then the values of A and B respectively are
- KCET - 2023
- limits of trigonometric functions
- The Curie temperatures of Cobalt and iron are 1400K and 1000K respectively. At T = 1600K , the ratio of magnetic susceptibility of Cobalt to that of iron is
- KCET - 2023
- Magnetism and matter
- A particle is in uniform circular motion. Related to one complete revolution of the particle, which among the stataments is incorrect ?
- KCET - 2023
- Uniform Circular Motion
- The modulus of the complex number \(\frac{(1+i)^2(1+3i)}{(2-6i)(2-2i)}\) is
- KCET - 2023
- complex numbers
- The energy gap of an LED is 2.4 eV. When the LED is switched ‘ON’, the momentum of the emitted photons is
- KCET - 2023
- Semiconductor electronics: materials, devices and simple circuits
Concepts Used:
Concentration of Ore
The concentration of ore, also known as ore enrichment, is the process of removing gangue particles from ore in order to enhance the percentage of metal in the ore. The difference in physical or chemical properties of the ore and the impurities determines the procedures used to remove impurities from the ores.
Methods of Concentration of Ore:
- Hand-picking - It was the traditional system of directly concentrating ore with the hands. With the use of a hammer, the gangue or adhering solid matrix is removed from the ore in this procedure. The separation and identification of gangue are based on colour or lump form differences.
- Hydraulic Washing - On passing the ore via an upward stream of water, the lighter gangue particles are separated from the heavier metal ore. This is a gravity separation method.This process is used to enrich ores that are heavier than the gangue particles that are present in them. A stream of water is run through crushed and finely powdered ore in this procedure. Water washes away the lighter gangue particles, leaving the larger ore particles behind.
- Froth Floatation Process - The purpose of this process is to extract gangue from sulfide ores. The ore is pulverized and mixed with water to form a suspension. Collectors and Froth Stabilizers are added to this. Collectors like pine oils, fatty acids, etc. boost the metal part of the ore’s non-wettability, allowing it to form a froth.
SUBSCRIBE TO OUR NEWS LETTER
