We are given a thermodynamic process involving temperature changes. Let’s break down the problem step by step:
We start with the following temperature relationships:
We are given the temperature changes over a time interval and can use the following relationship between the initial and final temperatures:
\(T_0 = T\)
The first equation is based on the temperature change from \( 3T \) to \( 2T \) over 10 minutes:
\(\left(\frac{3T - 2T}{10}\right) = c_1 \left(\frac{3T + 2T}{2} - T\right) \) ....(\)
This equation is based on the fact that heat exchange rate is proportional to the temperature difference.
The second equation is based on the temperature change from \( 2T \) to \( T_f \) over 10 minutes:
\(\left(\frac{2T - T_f}{10}\right) = c_1 \left(\frac{2T + T_f}{2} - T\right) \) ....(i\)
Next, we need to take the ratio of the two equations (i) and (ii) to solve for the final temperature \( T_f \):
\(\frac{E(i)}{E(ii)} \Rightarrow \frac{\frac{T}{10}}{\frac{2T - T_f}{10}} = \frac{\frac{5T - 2T}{2}}{\frac{T_f}{2}}\)
After simplifying the equation, we get:
\(\frac{T}{2T - T_f} = \frac{3T}{T_f}\)
Rearranging this equation to solve for \( T_f \), we get:
\(T_f = 6T - 3T_f\)
Now, simplify further:
\(4T_f = 6T\)
Finally, we find the value of \( T_f \):
\(T_f = \frac{3}{2} T\)
The final temperature \( T_f \) is:
\(T_f = \frac{3}{2} T\)
A constant voltage of 50 V is maintained between the points A and B of the circuit shown in the figure. The current through the branch CD of the circuit is :
AB is a part of an electrical circuit (see figure). The potential difference \(V_A - V_B\), at the instant when current \(i = 2\) A and is increasing at a rate of 1 amp/second is:
A full wave rectifier circuit with diodes (\(D_1\)) and (\(D_2\)) is shown in the figure. If input supply voltage \(V_{in} = 220 \sin(100 \pi t)\) volt, then at \(t = 15\) msec: 
Two rods \(A\) and \(B\) of different materials are welded together as shown in figure. Their thermal conductivities are \(K_1\) and \(K_2\). The thermal conductivity of the composite rod will be :


A constant voltage of 50 V is maintained between the points A and B of the circuit shown in the figure. The current through the branch CD of the circuit is :
Which of the following statements are true?
A. Unlike Ga that has a very high melting point, Cs has a very low melting point.
B. On Pauling scale, the electronegativity values of N and C are not the same.
C. $Ar, K^{+}, Cl^{–}, Ca^{2+} and S^{2–}$ are all isoelectronic species.
D. The correct order of the first ionization enthalpies of Na, Mg, Al, and Si is Si $>$ Al $>$ Mg $>$ Na.
E. The atomic radius of Cs is greater than that of Li and Rb.
Choose the correct answer from the options given below: