List of top Engineering Graphics Questions on Graphic Design

Match the List-I with List-II for the given isometric projection of combination of solids:

If a label with “USE & CARE” instructions is to be pasted on the entire outer circumference of the bottom cylindrical portion, then the surface area of the label to be used will be __________.
(Hint : Lateral surface area of cylinder = $2\pi rh$)
 

Why grub screws are used to hold sleeve on a shaft?
Grub screws are also known as
Cylinder and hemisphere are examples of
The projections which are mostly used in the design process of this product is
Due to which of the following reason, usually pipes are made of standard length, not of desired length?
A thread with vertical and parallel flanks is called
The length of the metal end of a plain stud of diameter 30 mm is
Choose the correct option regarding screw threads.
(i) A screw thread formed on the surface of a cylinder is known as taper thread.
(ii) In single start thread lead \( L = 2P \).
(iii) In the practical use of the threads, clearance must be provided between the external and internal threads.
(iv) Root is the edge of the thread surface nearest to the axis in case of internal thread.
In a BUSH BEARING assembly, the inside of the bush is bored as a fit for .........

Read the following paragraph and answer the questions given below:
The given image is a fire-extinguisher. It is made up of a bigger cylindrical tank with a hemispherical portion on it. A very small cylindrical portion at the top has a valve assembly and a hose. Assume that the diameter of the hemispherical portion as 140 mm and height of the bottom cylindered portion as 350 mm.