Question:
Which ONE of the following offshore installations uses Dynamic Positioning System for station keeping?
Which ONE of the following offshore installations uses Dynamic Positioning System for station keeping?
Show Hint
Dynamic Positioning Systems are crucial for offshore rigs that require mobility and precise location holding.
Updated On: Jan 9, 2026
- Jacket
Jack-up
Semi-submersible
- Tension Leg Platform
Hide Solution
Verified By Collegedunia
The Correct Option is C
Solution and Explanation
Step 1: The semi-submersible platform uses a Dynamic Positioning System for station keeping, which helps maintain its position without anchoring.
Step 2: Other platforms like the jacket or jack-up use fixed structures or anchors. Tension Leg Platforms use tethers to keep their position.
Step 3: The correct answer is (C) Semi-submersible.
Was this answer helpful?
0
0
Top GATE PE Petroleum Production Operations Questions
- A Newtonian fluid is transported through a smooth horizontal pipe of diameter 1 m at a flow rate of 3.14 m³/s. The length of the pipe is 1 km. The viscosity of the oil is 0.02 Pa.s and its density is 800 kg/m³. Consider the Darcy friction factor (\( f \)) for turbulent flow in a smooth pipe is given as
\[ f = \frac{0.316}{{Re}^{0.25}} \] where \( {Re} \) is the Reynolds number.
Assuming fully-developed flow in the pipe, the pressure drop due to the frictional effect is .......... kPa (rounded off to two decimal places).
- An electrical submersible pump is to be installed to lift oil of 30° API in a 10000 ft deep well. The oil formation volume factor (\( B_o \)) is 1.25 rb/stb. The desired flow rate is 8000 stb/day. Minimum suction pressure of the chosen pump is 200 psi. Inflow performance relationship shows a flowing bottomhole pressure of 2820 psi at the desired flow rate.
Assuming casing pressure and weight of the gas in the annulus to be negligible, the minimum pump setting depth is .......... ft (rounded off to one decimal place).
- The laboratory analysis data obtained from the core is as follows:
Weight of clean dry core in air = 30 g
Weight of core completely saturated with oil = 32 g
Weight of saturated core completely immersed in oil = 24 g
If the density of oil used for saturation of core during the experiment is 0.88 g/cc, then the effective porosity of the core is .......... % (rounded off to two decimal places).
The effect of pressure on various properties of black oil is shown in the figure. The bubble point pressure is \(P_b\).
Which of the following option(s) is/are CORRECT?
- GATE PE - 2025
- Petroleum Production Operations
- Multiphase Flow
- An electrical submersible pump is to be installed to lift oil of \(30^\circ API\) in a 10000 ft deep well. The oil formation volume factor (\(B_o\)) is \(1.25 \, rb/stb\). The desired flow rate is \(8000 \, stb/day\). Minimum suction pressure of the chosen pump is \(200 \, psi\). Inflow performance relationship shows a flowing bottomhole pressure of \(2820 \, psi\) at the desired flow rate. Assuming casing pressure and weight of the gas in the annulus to be negligible, the minimum pump setting depth is \(\underline{\hspace{1cm}} \, ft\) (rounded off to one decimal place).
- GATE PE - 2025
- Petroleum Production Operations
- Multiphase Flow
View More Questions
Top GATE PE Offshore Structure Questions
- An underwater riser with an outer diameter of 250 mm and wall thickness of 20 mm is subjected to tension and pressure. The effective tension is $1200$ kN wherein the internal and external pressures of the riser are $25$ MPa and $6$ MPa, respectively. The true wall tension in the riser is $\times 10^{6}$ N (rounded to two decimal places).
- GATE PE - 2023
- Petroleum Production Operations
- Offshore Structure
- A four–column semi–submersible floater is located offshore. The diameter of each column is $5~\text{m}$. Consider the total displaced weight of seawater of the semi–submersible as $4000~\text{tonnes}$. Assume added mass contribution as $50\%$ of the semi–submersible weight, and seawater density as $1025~\text{kg/m}^3$. (Acceleration due to gravity $=9.81~\text{m/s}^2$.) The natural period of oscillation of the floater in vertical mode is __________ seconds (rounded to one decimal place).
- GATE PE - 2023
- Petroleum Production Operations
- Offshore Structure
- An empty steel pipeline with massless endcaps has an outer diameter, $D$, and thickness, $t$. The density of steel is $7850\ \mathrm{kg/m^3}$. The critical $D/t$ ratio at which the pipeline starts floating in seawater of density $1025\ \mathrm{kg/m^3}$ is _________ (rounded to two decimal places).
- GATE PE - 2023
- Petroleum Production Operations
- Offshore Structure
Figure shows an inextensible catenary mooring cable in still water. The submerged weight (per meter length), and the anchor radius are 100 kg/m and 50 m, respectively. If horizontal tension ($T_h$) in the catenary is 1600 kg, the catenary length (AB) is ............. m (rounded to two decimal places).
- GATE PE - 2023
- Petroleum Production Operations
- Offshore Structure
- Select ALL the safety system(s) that is/are required in an offshore platform.
- GATE PE - 2023
- Petroleum Production Operations
- Offshore Structure
View More Questions
Top GATE PE Questions
- Classification of kerogen is based on the relative amount of Carbon (C), Hydrogen (H) and Oxygen (O). Which ONE of the following options is CORRECT about Type II kerogen?
- GATE PE - 2026
- Geochemistry
- Which of the following option(s) is/are CORRECT for well testing analysis of a reservoir?
- GATE PE - 2026
- Reservoir capacity
- In a capillary rise experiment with a capillary tube of length $l_1$, water rises to a height $h$ such that $h<l_1$. If the capillary tube is cut to a length $l_2$ such that $l_2<h$, and the experiment is repeated, which of the following statements is/are CORRECT?
- GATE PE - 2026
- Petroleum Exploration and Drilling Engineering
- The porosity of a formation with matrix density of 2.65 g/cc and fluid density of 1.0 g/cc is 0.15. The formation has shear modulus of 30 GPa and bulk modulus of 36 GPa. The compressional wave velocity in the formation is _________ $\times 10^3$ m/s (rounded off to two decimal places).
- GATE PE - 2026
- Rock Physics
- A vertical well is drilled up to a depth of 4000 ft. Further drilling starts with 10 ppg of fresh mud and 50000 lbf weight on bit (WOB). An equivalent circulation density (ECD) of 10.75 ppg was recorded. The total circulation pressure loss is estimated to be 110 psi. The steel density is 65.5 ppg. The decrease in hook load is _________ lbf (rounded off to one decimal place). (Note: 1 ppg mud is equivalent to 0.052 psi/ft.)
- GATE PE - 2026
- Petroleum Exploration and Drilling Engineering
View More Questions