List of top Manufacturing Processes II Questions on Advanced Manufacturing asked in GATE PI

In a wire drawing of a perfectly-plastic material with flow stress of 300 MPa, the back tension is zero and front tension is 200 MPa. Assuming ideal deformation with zero friction, the percentage reduction of the cross-sectional area of the wire is .............
A worker is allowed half an hour personal time in a normal 8-hour shift. If the normal time for manufacturing a product is 5 minutes, the standard time (in seconds) is .............
During orthogonal cutting with a tool of 10° rake angle, the cutting and thrust forces are 900 N and 275 N, respectively. The coefficient of friction on the rake surface of the tool is .............
During orthogonal cutting with a tool of 10° rake angle, the cutting and thrust forces are 900 N and 275 N, respectively. The coefficient of friction on the rake surface of the tool is .............
The benefit(s) of product standardization is/are:
A worker is allowed half an hour personal time in a normal 8-hour shift. If the normal time for manufacturing a product is 5 minutes, the standard time (in seconds) is .............
In a wire drawing of a perfectly-plastic material with flow stress of 300 MPa, the back tension is zero and front tension is 200 MPa. Assuming ideal deformation with zero friction, the percentage reduction of the cross-sectional area of the wire is .............